Household automatic booster pump common misunderstanding

After people bought the home automatic booster pump, there are many mistakes often used in the process. The following Xiaobian will tell you about the misunderstandings after purchasing the home automatic booster pump. Misunderstanding of the common use of home automatic booster pump Misunderstanding 1: As long as it is an automatic booster pump, it will automatically work when it is bought and repacked (the type of automatic booster pump does not include the frequency conversion water supply system). This is a serious mistake. Automatic booster pump is divided into several types, automatic flow booster pump (4L / min flow to activate the pump automatically booster); pressure type automatic booster pump (sensor outlet pressure automatically boost pressure); electronic constant pressure pump (Through the flow and pressure control pump start work). Misunderstanding two: If the water pressure 0.8 kg I just add a 9 m head of the pump there is 1.7 kg (usually simple calculation of pressure: 10 m head can be equal to about 1 kg of water pressure) the concept is not accurate. Some users say: My home is a pump with a head lift of 6 meters ah good effect ah. The old house before the simple model, next to the kitchen is the bathroom, the water meter to the point of the pipeline between only 5 to 10 meters. Relative pipeline loss is minimal. The water pumped by the pump can reach the water point with very few tube losses. Room types are now hundreds of square area, water pipes criss-cross, extending in all directions was previously unimaginable. The length of the water pipe and the number of elbows have a serious impact on the rapid flow of water in the pipe. The longer the pipe is, the greater the energy consumed is, for example, the water is absorbed by a short pipette. Now it is absorbed by 10 pipettes, Which is hard? Of course it is hard to absorb the long tube. The longer the water pipe, the more water in the water pipe, the greater the friction coefficient between the water and the pipe wall. When the booster pump is working, it must first overcome the friction to promote the water flow. Therefore, the size of the pump power is directly related to the length of the pipeline. Misunderstanding three: self-priming pump pumping wells as a household booster pump. This is unreasonable, self-priming pump has a serious shortcomings, the pump pressure to close the pipeline pressurized, the pump pressure switch quickly to close the pressure, that is to say, when we use the water is relatively small when the pump will be because Pressure problems, the pump will open frequently in a short period of time to open the stop (because the water consumption is small, the pump about to stop the pressure to stop the work then the pump, but the water did not stop, the water pressure is lower than the pump start pressure, so the pump starts working , This will cause the water point of the water for a little while small) easily lead to sudden increase in the number of water suddenly caused by hot water hot water burns dangerous. The above is Xiaobian today to introduce the content, hope in life can give everyone help. Industrial Internet (Xiamen) Technology Co., Ltd. Asia Pump Network Editor: He Daohui (QQ / WeChat:) http://beng.liuti.cn/ (Service Hotline:)

Wall-Mount

Wall-Mount ,Brass Water Faucet-Upc Tap,Bathroom Faucet-Brass Taps

Watermark Faucet,Stainless Steel Faucets Co., Ltd. , http://www.htcfaucets.com