One-way pneumatic diaphragm pump works and common problems to solve

Asp. Pump Network As we all know, pneumatic diaphragm pump points and two-way. One-way pneumatic diaphragm pump is made of only one kind of aluminum alloy. Pneumatic double-diaphragm pump material is made of cast iron, aluminum alloy, engineering plastic and stainless steel. The flow rate is larger than that of single diaphragm pump. Please choose engineering plastic and stainless steel . This article describes the one-way pneumatic diaphragm pump. One-way pneumatic diaphragm pump is often composed of the implementing agencies and the valve, although the process of using gas pressure as the power source of the entire device, but also can not do without the driving role of electric energy, it can also be called the electric diaphragm Pump, in our understanding of the process of one-way pneumatic diaphragm pumps, tend to work on their principles and common problems to create interest in the following let us understand it. One-way pneumatic diaphragm pump works: One-way pneumatic diaphragm pump often have two internal chambers, respectively, the working chamber and the pneumatic chamber, the two chambers are separated by the diaphragm, when the outside air into the Is compressed and sent to the pneumatic chamber, because the pressure increases in the pneumatic chamber, making the diaphragm to move to the left, this time the spring will be compressed by force, the device will be forced to open the one-way valve, the working chamber The liquid will be pressured to be discharged, this time the air inlet will be closed, the air is discharged from the air outlet, the air pressure in the cavity is reduced, the diaphragm will be back to its original position, the air inlet is opened and the next working cycle is resumed Initially, one-way pneumatic diaphragm pump gradually achieve the task of conveying a variety of liquids, it is through this reciprocating movement. One-way pneumatic diaphragm pump usually appear part of the phenomenon of pneumatic parts can not work properly, this phenomenon may be due to leakage of air intake or pull the switch is not open and other reasons, then the staff need to unidirectional pneumatic diaphragm pump Air inlet inspection, including the hose check to see if there is a crack, and pull out the push-pull switch. If you use this type of diaphragm pump imports found that the diaphragm pump does not work properly, the media also appear bubbles, which should be its internal diaphragm is damaged, this time we should replace the diaphragm. If the unidirectional pneumatic diaphragm pump gas or liquid leakage during the work, it may be caused by aging equipment, this time should be leaking parts of the place should be replaced. With the increasing use of one-way pneumatic diaphragm pumps, to understand its working principle and solutions to common problems have become more people need to pay attention to the problem, I hope we can help give the front of the introduction of certain types of imports Membrane pumps can be one by one for everyone to understand, to help you solve the problems in the work process. This article belongs to Industrial Internet (Xiamen) Technology Co., Ltd., without written authorization, is forbidden to reprint, offenders will be held criminally responsible. Author: Asian pumps Network Editor: Ko Muk available (QQ / micro-channel: 97,129,095) starting: http: //beng.liuti.cn/ (service hotline:) Further Reading: Guangzhou IFAT China Building water exhibition

25-50mm calcium carbide

Calcium Carbide for Acetylene Gas,Calcium Carbide for Welding Gas,Chemical Formula Calcium Carbide

Medicinal Activated Carbon,Activatd Carbon Co., Ltd. , http://www.chactivatedcharcoal.com